How it works ? – Ergonomic Fingerboard for Climbers, Strength & Recovery Tool

 

🧠 See How It Works

Your fingers aren't flat. Your edge shouldn't be either.

🔍 The Problem With Traditional Hangboards

Standard hangboards are built with a single, flat edge.
But human fingers aren’t all the same length — which means each finger loads differently during training. The result?

  • Overuse of the middle fingers
  • Under-recruitment of the pinky and index
  • Uneven tension across joints and pulleys
  • Increased injury risk over time

⚙️ The Unlevel Edge Solution

Unlevel Edge is the first hangboard engineered to reflect your individual finger anatomy.
We custom-build each board to match the vertical offset between your PIP joints (the first knuckle from the palm) — aligning every finger into a biomechanically strong and safe position.

🧬 How It Works

  1. You measure your hand width and finger proportions (see [How to Measure] page).
  2. We create a custom edge with varying depths, so each finger rests at the correct height.
  3. When you hang, the load is shared equally across all fingers, joints stay in a neutral angle, and deep tissue is recruited safely.

The result?
✅ Better force production
✅ Lower fatigue
✅ Safer adaptation of connective tissue

🔁 One Edge to Rull Them All

Whether you're:

  • Rehabbing an injury
  • Warming up before a session
  • Training for maximum hangs
  • Or just building finger endurance

Unlevel Edge helps you target every finger efficiently — with less risk and more control.

📐 Custom by Design

  • Each Unlevel Edge is:
  • Built based on your actual measurements
  • Available in 2 high-quality materials (Carbon PLA & Wood PLA)
  • Compact, lightweight, and portable
  • Designed by climbers, for climbers

🚀 Ready to Try It?

Head over to How to Measure to get started — or join the waitlist and we’ll walk you through every step.